This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
manual:demos:ek_lm3s8962_iar [2016/10/27 23:20] voorburg |
manual:demos:ek_lm3s8962_iar [2023/12/04 22:42] (current) voorburg [Supported firmware update interfaces] |
||
---|---|---|---|
Line 3: | Line 3: | ||
===== Supported firmware update interfaces ===== | ===== Supported firmware update interfaces ===== | ||
- | ^ UART ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ | + | ^ RS232 ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ Modbus RTU ^ |
- | | Yes | Yes | No | No | No | | + | | Yes | Yes | No | No | No | No | |
===== Development Environment ===== | ===== Development Environment ===== | ||
Line 10: | Line 10: | ||
{{:manual:demos:ek_lm3s8962.jpg?200 |}} | {{:manual:demos:ek_lm3s8962.jpg?200 |}} | ||
- | This demo is targeted towards the [[http://www.ti.com/tool/ek-lm3s8962|Texas Instruments LM3S8962 Ethernet]] evaluation kit, with 256 kB internal Flash EEPROM and 64 kB internal RAM. | + | This demo is targeted towards the Texas Instruments LM3S8962 Ethernet evaluation kit, with 256 kB internal Flash EEPROM and 64 kB internal RAM. |
To program the bootloader into the internal flash on the LM3S8962 microcontroller, the In-Circuit Debugger Interface (ICDI), that is available on the board, was used. However, this is not required if you have another means of programming the internal flash. | To program the bootloader into the internal flash on the LM3S8962 microcontroller, the In-Circuit Debugger Interface (ICDI), that is available on the board, was used. However, this is not required if you have another means of programming the internal flash. | ||
Line 39: | Line 39: | ||
To download the demo program \Target\Demo\ARMCM3_LM3S_EK_LM3S8962_IAR\**Prog**\bin\**demoprog_ek_lm3s8962.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: | To download the demo program \Target\Demo\ARMCM3_LM3S_EK_LM3S8962_IAR\**Prog**\bin\**demoprog_ek_lm3s8962.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: | ||
- | * [[manual:uart_demo|Firmware updates using the UART communication interface]] | + | * [[manual:rs232_demo|Firmware updates using the RS232 communication interface]] |
* [[manual:can_demo|Firmware updates using the CAN communication interface]] | * [[manual:can_demo|Firmware updates using the CAN communication interface]] | ||
| |