User Tools

Site Tools


manual:demos:ek_lm3s6965_crossworks

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
manual:demos:ek_lm3s6965_crossworks [2016/10/27 23:18]
voorburg
manual:demos:ek_lm3s6965_crossworks [2020/02/06 16:45]
voorburg
Line 3: Line 3:
 ===== Supported firmware update interfaces ===== ===== Supported firmware update interfaces =====
  
-UART           ^ CAN             ^ USB          ^ TCP/​IP ​      ^ SD-card ​     ^+RS232          ​^ CAN             ^ USB          ^ TCP/​IP ​      ^ SD-card ​     ^
 | Yes            | No              | No           | Yes           | Yes          | | Yes            | No              | No           | Yes           | Yes          |
  
Line 10: Line 10:
 {{:​manual:​demos:​ek_lm3s6965.jpg?​200 |}} {{:​manual:​demos:​ek_lm3s6965.jpg?​200 |}}
  
-This demo is targeted towards the [[http://​www.ti.com/​tool/​ek-lm3s6965|Texas Instruments LM3S6965 Ethernet]] evaluation kit, with 256 kB internal Flash EEPROM and 64 kB internal RAM.+This demo is targeted towards the Texas Instruments LM3S6965 Ethernet evaluation kit, with 256 kB internal Flash EEPROM and 64 kB internal RAM.
  
 To program the bootloader into the internal flash on the LM3S6965 microcontroller,​ the In-Circuit Debugger Interface (ICDI), that is available on the board, was used. However, this is not required if you have another means of programming the internal flash. To program the bootloader into the internal flash on the LM3S6965 microcontroller,​ the In-Circuit Debugger Interface (ICDI), that is available on the board, was used. However, this is not required if you have another means of programming the internal flash.
Line 39: Line 39:
 To download the demo program \Target\Demo\ARMCM3_LM3S_EK_LM3S6965_Crossworks\**Prog**\bin\**demoprog_ek_lm3s6965.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: To download the demo program \Target\Demo\ARMCM3_LM3S_EK_LM3S6965_Crossworks\**Prog**\bin\**demoprog_ek_lm3s6965.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use:
  
-  * [[manual:uart_demo|Firmware updates using the UART communication interface]]+  * [[manual:rs232_demo|Firmware updates using the RS232 communication interface]]
   * [[manual:​net_demo|Firmware updates using the TCP/IP communication interface]]   * [[manual:​net_demo|Firmware updates using the TCP/IP communication interface]]
   * [[manual:​sdcard_demo|Firmware updates from SD-card]]   * [[manual:​sdcard_demo|Firmware updates from SD-card]]
manual/demos/ek_lm3s6965_crossworks.txt ยท Last modified: 2020/02/06 16:45 by voorburg