manual:demos:ek_lm3s6965_gcc
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
manual:demos:ek_lm3s6965_gcc [2017/08/16 15:40] voorburg [Building the Demo Program] |
manual:demos:ek_lm3s6965_gcc [2020/02/06 16:44] voorburg |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ===== Supported firmware update interfaces ===== | ===== Supported firmware update interfaces ===== | ||
| - | ^ UART ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ | + | ^ RS232 ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ |
| | Yes | No | No | Yes | Yes | | | Yes | No | No | Yes | Yes | | ||
| Line 10: | Line 10: | ||
| {{:manual:demos:ek_lm3s6965.jpg?200 |}} | {{:manual:demos:ek_lm3s6965.jpg?200 |}} | ||
| - | This demo is targeted towards the [[http://www.ti.com/tool/ek-lm3s6965|Texas Instruments LM3S6965 Ethernet]] evaluation kit, with 256 kB internal Flash EEPROM and 64 kB internal RAM. | + | This demo is targeted towards the Texas Instruments LM3S6965 Ethernet evaluation kit, with 256 kB internal Flash EEPROM and 64 kB internal RAM. |
| To program the bootloader into the internal flash on the LM3S6965 microcontroller, the LM Flash Programmer utility was used in combination with the In-Circuit Debugger Interface (ICDI), that is available on the board. However, this is not required if you have another means of programming the internal flash. | To program the bootloader into the internal flash on the LM3S6965 microcontroller, the LM Flash Programmer utility was used in combination with the In-Circuit Debugger Interface (ICDI), that is available on the board. However, this is not required if you have another means of programming the internal flash. | ||
| Line 79: | Line 79: | ||
| To download the demo program \Target\Demo\ARMCM3_LM3S_EK_LM3S6965_GCC\**Prog**\bin\**demoprog_ek_lm3s6965.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: | To download the demo program \Target\Demo\ARMCM3_LM3S_EK_LM3S6965_GCC\**Prog**\bin\**demoprog_ek_lm3s6965.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: | ||
| - | * [[manual:uart_demo|Firmware updates using the UART communication interface]] | + | * [[manual:rs232_demo|Firmware updates using the RS232 communication interface]] |
| * [[manual:net_demo|Firmware updates using the TCP/IP communication interface]] | * [[manual:net_demo|Firmware updates using the TCP/IP communication interface]] | ||
| * [[manual:sdcard_demo|Firmware updates from SD-card]] | * [[manual:sdcard_demo|Firmware updates from SD-card]] | ||
manual/demos/ek_lm3s6965_gcc.txt ยท Last modified: 2023/12/04 22:41 by voorburg
Page Tools
