Navigation
External Links
Donate
Show your appreciation for OpenBLT
and support future development by
donating.
External Links
Donate
Show your appreciation for OpenBLT
and support future development by
donating.
This is an old revision of the document!
UART | CAN | USB | TCP/IP | SD-card |
---|---|---|---|---|
Yes | Yes | No | No | No |
This demo is targeted towards the Texas Instruments LM3S8962 Ethernet evaluation kit, with 256 kB internal Flash EEPROM and 64 kB internal RAM.
To program the bootloader into the internal flash on the LM3S6965 microcontroller, the LM Flash Programmer utility was used in combination with the In-Circuit Debugger Interface (ICDI), that is available on the board. However, this is not required if you have another means of programming the internal flash.
The demo programs are pre-configured for building with the Codesourcery G++ Lite (Target OS EABI) toolchain. Alternatively, you can use the GCC ARM Embedded toolchain.
Before the bootloader can be used, it needs to be built and programmed into the LM3S8962's internal flash memory. The steps in this section only need to be done once.
Batch files are added to aid in building the software program. First clean the bootloader program by double-clicking the file “\Target\Demo\ARMCM3_LM3S_EK_LM3S8962_GCC\Boot\cmd\clean.bat”. Next, build the bootloader program by double-clicking the file “\Target\Demo\ARMCM3_LM3S_EK_LM3S8962_GCC\Boot\cmd\build.bat”. The output should look like:
+++ Compiling [hooks.o] +++ Compiling [main.o] +++ Compiling [boot.o] ... +++ Linking [openblt_ek_lm3s8962.elf] ... +++ Build complete [openblt_ek_lm3s8962.bin]
The bootloader program is now ready to be programmed into the internal flash memory of the LM3S8962. Using your favorite programmer, flash the bootloader using one of the following files, depending on what file type your programmer supports:
Batch files are added to aid in building the demo program. First clean the demo program by double-clicking the file “\Target\Demo\ARMCM3_LM3S_EK_LM3S8962_GCC\Prog\cmd\clean.bat”. Next, build the demo program by double-clicking the file “\Target\Demo\ARMCM3_LM3S_EK_LM3S8962_GCC\Prog\cmd\build.bat”. The output should look like:
+++ Compiling [boot.c] +++ Compiling [main.c] ... +++ Linking [demoprog_ek_lm3s8962.elf] ... +++ Build complete [demoprog_ek_lm3s8962.srec]
The output file is
To download the demo program \Target\Demo\ARMCM3_LM3S_EK_LM3S8962_GCC\Prog\bin\demoprog_ek_lm3s8962.srec using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: