Differences

This shows you the differences between two versions of the page.

--- manual:demos:infineon_xmc1400_boot_kit_gcc [2017/04/24 14:59]
voorburg [Building and programming the Bootloader]
+++ manual:demos:infineon_xmc1400_boot_kit_gcc [2017/04/24 15:03]
voorburg [Firmware update procedure]
@@ Line 43: / Line 43: @@
   * \Target\Demo\ARMCM0_XMC1_XMC1400_Boot_Kit_GCC\**Boot**\Debug\**openblt_xmc1400.srec**
+Note that after closing the debug session in Eclipse, the on-board Segger J-Link interface halts the CPU. If you want to continue running the bootloader program, a reset of the microcontroller is needed. An easy method to achieve this is by disconnecting and then reconnecting the USB cable.
 ===== Building the Demo Program =====
@@ Line 55: / Line 55: @@
 ===== Firmware update procedure =====
-To download the demo program \Target\Demo\ARMCM0_XMC1_XMC1400_Boot_Kit_IAR\**Prog**\bin\**demoprog_xmc1400.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use:
+To download the demo program \Target\Demo\ARMCM0_XMC1_XMC1400_Boot_Kit_GCC\**Prog**\Debug\**demoprog_xmc1400.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use:
   * [[manual:uart_demo|Firmware updates using the UART communication interface]]
   * [[manual:can_demo|Firmware updates using the CAN communication interface]]

OpenBLT Bootloader