User Tools

Site Tools


manual:demos:infineon_xmc1400_boot_kit_gcc

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
manual:demos:infineon_xmc1400_boot_kit_gcc [2017/04/24 15:03]
voorburg [Firmware update procedure]
manual:demos:infineon_xmc1400_boot_kit_gcc [2019/08/14 13:12]
voorburg [Development Environment]
Line 10: Line 10:
 {{:​manual:​demos:​infineon_xmc1400_boot_kit.jpg?​200 |}} {{:​manual:​demos:​infineon_xmc1400_boot_kit.jpg?​200 |}}
  
-This demo is targeted towards the [[http://​www.infineon.com/​cms/​en/​product/​evaluation-boards/​KIT_XMC14_BOOT_001/productType.html?​productType=5546d46250cc1fdf015144a2102e1191|Infineon XMC1400 Boot Kit]] board, with 200 kB internal Flash EEPROM and 16 kB internal RAM.+This demo is targeted towards the [[https://​www.infineon.com/​cms/​en/​product/​evaluation-boards/​kit_xmc14_boot_001/|Infineon XMC1400 Boot Kit]] board, with 200 kB internal Flash EEPROM and 16 kB internal RAM.
  
 To program the bootloader into the internal flash on the XMC1400 microcontroller,​ the on-board [[http://​www.segger.com/​development-tools.html|Segger J-Link]] JTAG interface was used. However, this is not required if you have another means of programming the internal flash. ​ To program the bootloader into the internal flash on the XMC1400 microcontroller,​ the on-board [[http://​www.segger.com/​development-tools.html|Segger J-Link]] JTAG interface was used. However, this is not required if you have another means of programming the internal flash. ​
Line 46: Line 46:
 ===== Building the Demo Program ===== ===== Building the Demo Program =====
  
-When using IAR EWARM, simply open the workspace from within ​the Embedded WorkbenchThe workspace file (xmc1400.eww) ​is located at: \Target\Demo\ARMCM0_XMC1_XMC1400_Boot_Kit_IAR\**Prog**\ide\Once opened, select //Project->Rebuild ​All// from the menu to compile all the demo program sources and link the together into the final executable.+Set the project as the active project in EclipseThis is achieved by right-clicking the **Prog** ​project in the project navigator called //C/C++ Projects//From the context menu, select //Set Active ​Project//. Next, select //Project → Rebuild ​Active Project// from the menu to compile all the user program sources and link them together into the final executable.
  
 The output file is The output file is
  
-  * \Target\Demo\ARMCM0_XMC1_XMC1400_Boot_Kit_IAR\**Prog**\bin\**demoprog_xmc1400.srec**+  * \Target\Demo\ARMCM0_XMC1_XMC1400_Boot_Kit_GCC\**Prog**\Debug\**demoprog_xmc1400.srec**
  
  
manual/demos/infineon_xmc1400_boot_kit_gcc.txt · Last modified: 2020/02/06 16:47 by voorburg