manual:demos:infineon_xmc1400_boot_kit_gcc
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
manual:demos:infineon_xmc1400_boot_kit_gcc [2017/04/24 15:03] voorburg [Firmware update procedure] |
manual:demos:infineon_xmc1400_boot_kit_gcc [2019/09/24 22:12] 127.0.0.1 external edit |
||
|---|---|---|---|
| Line 10: | Line 10: | ||
| {{:manual:demos:infineon_xmc1400_boot_kit.jpg?200 |}} | {{:manual:demos:infineon_xmc1400_boot_kit.jpg?200 |}} | ||
| - | This demo is targeted towards the [[http://www.infineon.com/cms/en/product/evaluation-boards/KIT_XMC14_BOOT_001/productType.html?productType=5546d46250cc1fdf015144a2102e1191|Infineon XMC1400 Boot Kit]] board, with 200 kB internal Flash EEPROM and 16 kB internal RAM. | + | This demo is targeted towards the [[https://www.infineon.com/cms/en/product/evaluation-boards/kit_xmc14_boot_001/|Infineon XMC1400 Boot Kit]] board, with 200 kB internal Flash EEPROM and 16 kB internal RAM. |
| To program the bootloader into the internal flash on the XMC1400 microcontroller, the on-board [[http://www.segger.com/development-tools.html|Segger J-Link]] JTAG interface was used. However, this is not required if you have another means of programming the internal flash. | To program the bootloader into the internal flash on the XMC1400 microcontroller, the on-board [[http://www.segger.com/development-tools.html|Segger J-Link]] JTAG interface was used. However, this is not required if you have another means of programming the internal flash. | ||
| Line 46: | Line 46: | ||
| ===== Building the Demo Program ===== | ===== Building the Demo Program ===== | ||
| - | When using IAR EWARM, simply open the workspace from within the Embedded Workbench. The workspace file (xmc1400.eww) is located at: \Target\Demo\ARMCM0_XMC1_XMC1400_Boot_Kit_IAR\**Prog**\ide\. Once opened, select //Project->Rebuild All// from the menu to compile all the demo program sources and link the together into the final executable. | + | Set the project as the active project in Eclipse. This is achieved by right-clicking the **Prog** project in the project navigator called //C/C++ Projects//. From the context menu, select //Set Active Project//. Next, select //Project → Rebuild Active Project// from the menu to compile all the user program sources and link them together into the final executable. |
| The output file is | The output file is | ||
| - | * \Target\Demo\ARMCM0_XMC1_XMC1400_Boot_Kit_IAR\**Prog**\bin\**demoprog_xmc1400.srec** | + | * \Target\Demo\ARMCM0_XMC1_XMC1400_Boot_Kit_GCC\**Prog**\Debug\**demoprog_xmc1400.srec** |
manual/demos/infineon_xmc1400_boot_kit_gcc.txt · Last modified: 2023/12/04 22:39 by voorburg
Page Tools
