manual:demos:infineon_xmc1400_boot_kit_iar
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
manual:demos:infineon_xmc1400_boot_kit_iar [2016/12/21 11:36] voorburg [Building the Demo Program] |
manual:demos:infineon_xmc1400_boot_kit_iar [2019/08/14 13:12] voorburg [Development Environment] |
||
|---|---|---|---|
| Line 10: | Line 10: | ||
| {{:manual:demos:infineon_xmc1400_boot_kit.jpg?200 |}} | {{:manual:demos:infineon_xmc1400_boot_kit.jpg?200 |}} | ||
| - | This demo is targeted towards the [[http://www.infineon.com/cms/en/product/evaluation-boards/KIT_XMC14_BOOT_001/productType.html?productType=5546d46250cc1fdf015144a2102e1191|Infineon XMC1400 Boot Kit]] board, with 200 kB internal Flash EEPROM and 16 kB internal RAM. | + | This demo is targeted towards the [[https://www.infineon.com/cms/en/product/evaluation-boards/kit_xmc14_boot_001/|Infineon XMC1400 Boot Kit]] board, with 200 kB internal Flash EEPROM and 16 kB internal RAM. |
| To program the bootloader into the internal flash on the XMC1400 microcontroller, the on-board [[http://www.segger.com/development-tools.html|Segger J-Link]] JTAG interface was used. However, this is not required if you have another means of programming the internal flash. | To program the bootloader into the internal flash on the XMC1400 microcontroller, the on-board [[http://www.segger.com/development-tools.html|Segger J-Link]] JTAG interface was used. However, this is not required if you have another means of programming the internal flash. | ||
| Line 41: | Line 41: | ||
| ===== Firmware update procedure ===== | ===== Firmware update procedure ===== | ||
| - | To download the demo program \Target\Demo\ARMCM0_STM32F0_Discovery_STM32F051_IAR\**Prog**\bin\**demoprog_stm32f051.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: | + | To download the demo program \Target\Demo\ARMCM0_XMC1_XMC1400_Boot_Kit_IAR\**Prog**\bin\**demoprog_xmc1400.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: |
| * [[manual:uart_demo|Firmware updates using the UART communication interface]] | * [[manual:uart_demo|Firmware updates using the UART communication interface]] | ||
| + | * [[manual:can_demo|Firmware updates using the CAN communication interface]] | ||
manual/demos/infineon_xmc1400_boot_kit_iar.txt ยท Last modified: 2023/12/04 22:39 by voorburg
Page Tools
