This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
manual:demos:infineon_xmc1400_boot_kit_iar [2019/08/14 13:12] voorburg [Development Environment] |
manual:demos:infineon_xmc1400_boot_kit_iar [2019/08/14 13:12] voorburg [Development Environment] |
||
---|---|---|---|
Line 10: | Line 10: | ||
{{:manual:demos:infineon_xmc1400_boot_kit.jpg?200 |}} | {{:manual:demos:infineon_xmc1400_boot_kit.jpg?200 |}} | ||
- | This demo is targeted towards the [https://www.infineon.com/cms/en/product/evaluation-boards/kit_xmc14_boot_001/|Infineon XMC1400 Boot Kit]] board, with 200 kB internal Flash EEPROM and 16 kB internal RAM. | + | This demo is targeted towards the [[https://www.infineon.com/cms/en/product/evaluation-boards/kit_xmc14_boot_001/|Infineon XMC1400 Boot Kit]] board, with 200 kB internal Flash EEPROM and 16 kB internal RAM. |
To program the bootloader into the internal flash on the XMC1400 microcontroller, the on-board [[http://www.segger.com/development-tools.html|Segger J-Link]] JTAG interface was used. However, this is not required if you have another means of programming the internal flash. | To program the bootloader into the internal flash on the XMC1400 microcontroller, the on-board [[http://www.segger.com/development-tools.html|Segger J-Link]] JTAG interface was used. However, this is not required if you have another means of programming the internal flash. |