This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
manual:demos:nucleo_f091rc_gcc [2017/07/19 15:13] voorburg |
manual:demos:nucleo_f091rc_gcc [2017/07/19 15:14] voorburg [Building and programming the Bootloader] |
||
---|---|---|---|
Line 28: | Line 28: | ||
Before the bootloader can be used, it needs to be built and programmed into the STM32F091's internal flash memory. The steps in this section only need to be done once. | Before the bootloader can be used, it needs to be built and programmed into the STM32F091's internal flash memory. The steps in this section only need to be done once. | ||
- | To build the bootloader, open a command prompt in directory **\Target\Demo\RMCM0_STM32F0_Nucleo_F091RC_GCC\Boot\** and run the command: | + | To build the bootloader, open a command prompt in directory **\Target\Demo\ARMCM0_STM32F0_Nucleo_F091RC_GCC\Boot\** and run the command: |
<code> | <code> |