This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
manual:demos:nucleo_f091rc_iar [2017/07/19 12:50] voorburg [Building and programming the Bootloader] |
manual:demos:nucleo_f091rc_iar [2023/12/04 22:17] (current) voorburg [Supported firmware update interfaces] |
||
---|---|---|---|
Line 3: | Line 3: | ||
===== Supported firmware update interfaces ===== | ===== Supported firmware update interfaces ===== | ||
- | ^ UART ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ | + | ^ RS232 ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ Modbus RTU ^ |
- | | Yes | Yes | No | No | No | | + | | Yes | Yes | No | No | No | No | |
===== Development Environment ===== | ===== Development Environment ===== | ||
Line 32: | Line 32: | ||
===== Building the Demo Program ===== | ===== Building the Demo Program ===== | ||
- | When using EmBitz, simply open the project file by double-clicking the file: \Target\Demo\ARMCM0_STM32F0_Nucleo_F091RC_GCC\**Prog**\ide\**stm32f091.ebp** from the Windows Explorer. To build the demo program, select //Build -> Rebuild all target files// from the program's menu. | + | When using IAR EWARM, simply open the workspace from within the Embedded Workbench. The workspace file (stm32f091.eww) is located at: \Target\Demo\ARMCM0_STM32F0_Nucleo_F091RC_IAR\**Prog**\ide\. Once opened, select //Project->Rebuild All// from the menu to compile all the demo program sources and link the together into the final executable. |
The output file is | The output file is | ||
- | * \Target\Demo\ARMCM0_STM32F0_Nucleo_F091RC_GCC\**Prog**\bin\**demoprog_stm32f091.srec** | + | * \Target\Demo\ARMCM0_STM32F0_Nucleo_F091RC_IAR\**Prog**\bin\**demoprog_stm32f091.srec** |
===== Firmware update procedure ===== | ===== Firmware update procedure ===== | ||
- | To download the demo program \Target\Demo\ARMCM0_STM32F0_Nucleo_F091RC_GCC\**Prog**\bin\**demoprog_stm32f091.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: | + | To download the demo program \Target\Demo\ARMCM0_STM32F0_Nucleo_F091RC_IAR\**Prog**\bin\**demoprog_stm32f091.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: |
- | * [[manual:uart_demo|Firmware updates using the UART communication interface]] | + | * [[manual:rs232_demo|Firmware updates using the RS232 communication interface]] |
* [[manual:can_demo|Firmware updates using the CAN communication interface]] | * [[manual:can_demo|Firmware updates using the CAN communication interface]] | ||