manual:demos:nucleo_f103rb_gcc
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
manual:demos:nucleo_f103rb_gcc [2017/05/23 19:18] voorburg [Firmware update procedure] |
manual:demos:nucleo_f103rb_gcc [2017/05/23 20:27] voorburg [Development Environment] |
||
|---|---|---|---|
| Line 12: | Line 12: | ||
| This demo is targeted towards the [[http://www.st.com/en/evaluation-tools/nucleo-f103rb.html|Nucleo-F103RB]] board, with 128 kB internal Flash EEPROM and 20 kB internal RAM. | This demo is targeted towards the [[http://www.st.com/en/evaluation-tools/nucleo-f103rb.html|Nucleo-F103RB]] board, with 128 kB internal Flash EEPROM and 20 kB internal RAM. | ||
| - | To program the bootloader into the internal flash on the on-board ST-Link debugger interface was used. Firmware updates via the serial communication port are preconfigured to use the virtual COM-port offered by the ST-Link. This means that no additional hardware is needed, besides a standard micro-USB cable. | + | To program the bootloader into the internal flash, the on-board ST-Link debugger interface was used. Firmware updates via the serial communication port are preconfigured to use the virtual COM-port offered by the ST-Link. This means that no additional hardware is needed, besides a standard micro-USB cable. |
| The demo programs are pre-configured for building with the {{:manual:arm-2013.11-24-arm-none-eabi.zip?linkonly|Codesourcery G++ Lite}} (Target OS EABI) toolchain. Alternatively, you can use the [[manual:demos:gcc_arm_embedded|GCC ARM Embedded]] toolchain. | The demo programs are pre-configured for building with the {{:manual:arm-2013.11-24-arm-none-eabi.zip?linkonly|Codesourcery G++ Lite}} (Target OS EABI) toolchain. Alternatively, you can use the [[manual:demos:gcc_arm_embedded|GCC ARM Embedded]] toolchain. | ||
manual/demos/nucleo_f103rb_gcc.txt ยท Last modified: 2023/12/04 22:18 by voorburg
Page Tools
