This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
manual:demos:nucleo_f303k8_gcc [2016/11/14 17:35] voorburg [Firmware update procedure] |
manual:demos:nucleo_f303k8_gcc [2017/07/11 10:33] voorburg [Development Environment] |
||
---|---|---|---|
Line 14: | Line 14: | ||
To compile the demo programs you can use the [[http://www.emblocks.org/|EmBitz]] development environment from Em::Blocks. The version that was used to create these demo programs was {{:manual:embitz_1_00.zip?linkonly|EmBitz version 1.00}}. | To compile the demo programs you can use the [[http://www.emblocks.org/|EmBitz]] development environment from Em::Blocks. The version that was used to create these demo programs was {{:manual:embitz_1_00.zip?linkonly|EmBitz version 1.00}}. | ||
- | To program the bootloader into the internal flash on the on-board ST-Link debugger interface was used. Firmware updates via the serial communication port are preconfigured to use the virtual COM-port offered by the ST-Link. This means that no additional hardware is needed, besides a standard micro-USB cable. | + | To program the bootloader into the internal flash, the on-board ST-Link debugger interface was used. Firmware updates via the serial communication port are preconfigured to use the virtual COM-port offered by the ST-Link. This means that no additional hardware is needed, besides a standard micro-USB cable. |