Differences

This shows you the differences between two versions of the page.

--- manual:demos:nucleo_f303k8_truestudio [2017/07/11 11:02]
voorburg created
+++ manual:demos:nucleo_f303k8_truestudio [2019/09/24 22:12]
127.0.0.1 external edit
@@ Line 12: / Line 12: @@
 This demo is targeted towards the [[http://www.st.com/content/st_com/en/products/evaluation-tools/product-evaluation-tools/mcu-eval-tools/stm32-mcu-eval-tools/stm32-mcu-nucleo/nucleo-f303k8.html|Nucleo-F303K8]] board, with 64 kB internal Flash EEPROM and 12 kB internal RAM.
-To compile the demo programs you can use the [[https://atollic.com/truestudio/|Atollic TrueStudio]] development environment. The freely available Lite-edition suffices. Note the Atollic TrueStudio is cross-platform. The information outlined on this page applies to both Microsoft Windows and Linux users.
+To compile the demo programs you can use the [[https://atollic.com/truestudio/|Atollic TrueStudio]] development environment. Note the Atollic TrueStudio is cross-platform. The information outlined on this page applies to both Microsoft Windows and Linux users.
 To program the bootloader into the internal flash, the on-board ST-Link debugger interface was used. Firmware updates via the serial communication port are preconfigured to use the virtual COM-port offered by the ST-Link. This means that no additional hardware is needed, besides a standard micro-USB cable.

OpenBLT Bootloader