This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
manual:demos:nucleo_f746zg_cubeide [2020/09/22 17:09] voorburg |
manual:demos:nucleo_f746zg_cubeide [2021/09/02 11:08] voorburg [Building and programming the Bootloader] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== ARM-CM7 STM32 Nucleo-F746ZG ====== | + | ====== ARM-CM7 STM32 Nucleo-F746ZG STM32CubeIDE ====== |
===== Supported firmware update interfaces ===== | ===== Supported firmware update interfaces ===== | ||
Line 35: | Line 35: | ||
- Set the project as the active project in Eclipse. This is achieved by clicking the **Boot** project in the //Project Explorer// to select it. | - Set the project as the active project in Eclipse. This is achieved by clicking the **Boot** project in the //Project Explorer// to select it. | ||
- | - Delete the file \Target\Demo\ARMCM7_STM32F7_Nucleo_F746ZG_CubeIDE\**Boot**\Debug\**openblt_stm32f746.elf**. | ||
- Next, right-click the **Boot** project in the //Project Explorer// and select //Refresh// from the popup menu. | - Next, right-click the **Boot** project in the //Project Explorer// and select //Refresh// from the popup menu. | ||
- Finally, right-click the **Boot** project in the //Project Explorer// and select //Build Project// from the popup menu to compile all the bootloader sources and link them together into the final executable. | - Finally, right-click the **Boot** project in the //Project Explorer// and select //Build Project// from the popup menu to compile all the bootloader sources and link them together into the final executable. | ||
Line 48: | Line 47: | ||
===== Building the Demo Program ===== | ===== Building the Demo Program ===== | ||
- | Set the project as the active project in Eclipse. This is achieved by clicking the **Prog** project in the //Project Explorer// to select it. Right-click the **Prog** project in the //Project Explorer// and select //Clean Project// from the popup menu. Next, right-click the **Prog** project in the //Project Explorer// and select //Refresh// from the popup menu. Finally, right-click the **Prog** project in the //Project Explorer// and select //Build Project// from the popup menu to compile all the user program sources and link them together into the final executable. | + | - Set the project as the active project in Eclipse. This is achieved by clicking the **Prog** project in the //Project Explorer// to select it. |
+ | - Delete the file \Target\Demo\ARMCM7_STM32F7_Nucleo_F746ZG_CubeIDE\**Prog**\Debug\**demoprog_stm32f746.elf**. | ||
+ | - Next, right-click the **Prog** project in the //Project Explorer// and select //Refresh// from the popup menu. | ||
+ | - Finally, right-click the **Prog** project in the //Project Explorer// and select //Build Project// from the popup menu to compile all the user program sources and link them together into the final executable. | ||
+ | |||
The output file is | The output file is | ||