manual:demos:nucleo_f746zg_cubeide
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
manual:demos:nucleo_f746zg_cubeide [2020/09/23 16:24] voorburg [ARM-CM7 STM32 Nucleo-F746ZG] |
manual:demos:nucleo_f746zg_cubeide [2023/12/04 22:30] (current) voorburg [Supported firmware update interfaces] |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ===== Supported firmware update interfaces ===== | ===== Supported firmware update interfaces ===== | ||
| - | ^ RS232 ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ | + | ^ RS232 ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ Modbus RTU ^ |
| - | | Yes | Yes | Yes | No | No | | + | | Yes | Yes | Yes | No | No | No | |
| ===== Development Environment ===== | ===== Development Environment ===== | ||
| Line 35: | Line 35: | ||
| - Set the project as the active project in Eclipse. This is achieved by clicking the **Boot** project in the //Project Explorer// to select it. | - Set the project as the active project in Eclipse. This is achieved by clicking the **Boot** project in the //Project Explorer// to select it. | ||
| - | - Delete the file \Target\Demo\ARMCM7_STM32F7_Nucleo_F746ZG_CubeIDE\**Boot**\Debug\**openblt_stm32f746.elf**. | ||
| - Next, right-click the **Boot** project in the //Project Explorer// and select //Refresh// from the popup menu. | - Next, right-click the **Boot** project in the //Project Explorer// and select //Refresh// from the popup menu. | ||
| - Finally, right-click the **Boot** project in the //Project Explorer// and select //Build Project// from the popup menu to compile all the bootloader sources and link them together into the final executable. | - Finally, right-click the **Boot** project in the //Project Explorer// and select //Build Project// from the popup menu to compile all the bootloader sources and link them together into the final executable. | ||
| Line 49: | Line 48: | ||
| - Set the project as the active project in Eclipse. This is achieved by clicking the **Prog** project in the //Project Explorer// to select it. | - Set the project as the active project in Eclipse. This is achieved by clicking the **Prog** project in the //Project Explorer// to select it. | ||
| - | - Delete the file \Target\Demo\ARMCM7_STM32F7_Nucleo_F746ZG_CubeIDE\**Prog**\Debug\**demoprog_stm32f746.elf**. | ||
| - Next, right-click the **Prog** project in the //Project Explorer// and select //Refresh// from the popup menu. | - Next, right-click the **Prog** project in the //Project Explorer// and select //Refresh// from the popup menu. | ||
| - Finally, right-click the **Prog** project in the //Project Explorer// and select //Build Project// from the popup menu to compile all the user program sources and link them together into the final executable. | - Finally, right-click the **Prog** project in the //Project Explorer// and select //Build Project// from the popup menu to compile all the user program sources and link them together into the final executable. | ||
manual/demos/nucleo_f746zg_cubeide.1600871089.txt.gz · Last modified: 2020/09/23 16:24 by voorburg
Page Tools
