manual:demos:nucleo_f746zg_gcc
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision Next revision Both sides next revision | ||
|
manual:demos:nucleo_f746zg_gcc [2018/12/10 12:54] voorburg created |
manual:demos:nucleo_f746zg_gcc [2018/12/10 12:55] voorburg [Development Environment] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== ARM-CM4 STM32 Nucleo-L476RG GCC ====== | + | ====== ARM-CM7 STM32 Nucleo-F746ZG GCC ====== |
| ===== Supported firmware update interfaces ===== | ===== Supported firmware update interfaces ===== | ||
| Line 8: | Line 8: | ||
| ===== Development Environment ===== | ===== Development Environment ===== | ||
| - | {{:manual:demos:stm32_nucleo_l476rg.png? |}} | + | {{:manual:demos:stm32_nucleo_f746zg.png? |}} |
| - | This demo is targeted towards the [[http://www.st.com/en/evaluation-tools/nucleo-l476rg.html|Nucleo-L476RG]] board, with 1 MB internal Flash EEPROM and 128 kB internal RAM. | + | This demo is targeted towards the [[https://www.st.com/en/evaluation-tools/nucleo-f746zg.html|Nucleo-F746ZG]] board, with 1 MB internal Flash EEPROM and 320 kB internal RAM. |
| To build the demo programs you can use the [[https://developer.arm.com/open-source/gnu-toolchain/gnu-rm|GNU ARM Embedded]] toolchain. | To build the demo programs you can use the [[https://developer.arm.com/open-source/gnu-toolchain/gnu-rm|GNU ARM Embedded]] toolchain. | ||
manual/demos/nucleo_f746zg_gcc.txt · Last modified: 2023/12/04 22:29 by voorburg
Page Tools
