This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
manual:demos:nucleo_f746zg_iar [2018/12/17 10:40] voorburg [Building the Demo Program] |
manual:demos:nucleo_f746zg_iar [2019/06/11 22:14] voorburg [Building the Demo Program] |
||
---|---|---|---|
Line 32: | Line 32: | ||
===== Building the Demo Program ===== | ===== Building the Demo Program ===== | ||
- | When using IAR EWARM, simply open the workspace from within the Embedded Workbench. The workspace file (stm32f746.eww) is located at: \Target\Demo\ARMCM4_STM32L4_Nucleo_L476RG_IAR\**Prog**\ide\. Once opened, select //Project->Rebuild All// from the menu to compile all the demo program sources and link the together into the final executable. | + | When using IAR EWARM, simply open the workspace from within the Embedded Workbench. The workspace file (stm32f746.eww) is located at: \Target\Demo\ARMCM7_STM32F7_Nucleo_F746ZG_IAR\**Prog**\ide\. Once opened, select //Project->Rebuild All// from the menu to compile all the demo program sources and link the together into the final executable. |
The output file is | The output file is | ||
Line 41: | Line 41: | ||
===== Firmware update procedure ===== | ===== Firmware update procedure ===== | ||
- | To download the demo program \Target\Demo\ARMCM4_STM32L4_Nucleo_L476RG_IAR\**Prog**\bin\**demoprog_stm32l476.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: | + | To download the demo program \Target\Demo\ARMCM7_STM32F7_Nucleo_F746ZG_IAR\**Prog**\bin\**demoprog_stm32f746.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: |
* [[manual:uart_demo|Firmware updates using the UART communication interface]] | * [[manual:uart_demo|Firmware updates using the UART communication interface]] |