manual:demos:olimex_stm32e407_gcc
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
manual:demos:olimex_stm32e407_gcc [2017/08/15 18:25] voorburg |
manual:demos:olimex_stm32e407_gcc [2019/09/24 22:12] 127.0.0.1 external edit |
||
|---|---|---|---|
| Line 4: | Line 4: | ||
| ^ UART ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ | ^ UART ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ | ||
| - | | Yes | Yes | Yes | Yes | Yes | | + | | Yes | Yes | No | No | Yes | |
| ===== Development Environment ===== | ===== Development Environment ===== | ||
| Line 31: | Line 31: | ||
| Before the bootloader can be used, it needs to be built and programmed into the STM32F407's internal flash memory. The steps in this section only need to be done once. | Before the bootloader can be used, it needs to be built and programmed into the STM32F407's internal flash memory. The steps in this section only need to be done once. | ||
| - | Batch files are added to aid in building the software program. First clean the bootloader program by double-clicking the file "\Target\Demo\ARMCM4_STM32F4_Olimex_STM32E407_GCC\**Boot**\cmd\**clean.bat**". Next, build the bootloader program by double-clicking the file "\Target\Demo\ARMCM4_STM32F4_Olimex_STM32E407_GCC\**Boot**\cmd\**build.bat**". The output should look like: | + | To build the bootloader, open a command prompt in directory **\Target\Demo\ARMCM4_STM32F4_Olimex_STM32E407_GCC\Boot\** and run the command: |
| + | |||
| + | <code> | ||
| + | make clean all | ||
| + | </code> | ||
| + | |||
| + | The expected output is: | ||
| <code> | <code> | ||
| Line 50: | Line 56: | ||
| ===== Building the Demo Program ===== | ===== Building the Demo Program ===== | ||
| - | Batch files are added to aid in building the demo program. First clean the demo program by double-clicking the file "\Target\Demo\ARMCM4_STM32F4_Olimex_STM32E407_GCC\**Prog**\cmd\**clean.bat**". Next, build the demo program by double-clicking the file "\Target\Demo\ARMCM4_STM32F4_Olimex_STM32E407_GCC\**Prog**\cmd\**build.bat**". The output should look like: | + | To build the user program, open a command prompt in directory **\Target\Demo\ARMCM4_STM32F4_Olimex_STM32E407_GCC\Prog\** and run the command: |
| + | |||
| + | <code> | ||
| + | make clean all | ||
| + | </code> | ||
| + | |||
| + | The expected output is: | ||
| <code> | <code> | ||
manual/demos/olimex_stm32e407_gcc.txt · Last modified: 2020/02/06 16:32 by voorburg
Page Tools
