This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
manual:demos:olimex_stm32e407_gcc [2017/08/15 18:26] voorburg [Building and programming the Bootloader] |
manual:demos:olimex_stm32e407_gcc [2019/01/07 10:57] voorburg [Supported firmware update interfaces] |
||
---|---|---|---|
Line 4: | Line 4: | ||
^ UART ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ | ^ UART ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ | ||
- | | Yes | Yes | Yes | Yes | Yes | | + | | Yes | Yes | No | No | Yes | |
===== Development Environment ===== | ===== Development Environment ===== | ||
Line 56: | Line 56: | ||
===== Building the Demo Program ===== | ===== Building the Demo Program ===== | ||
- | Batch files are added to aid in building the demo program. First clean the demo program by double-clicking the file "\Target\Demo\ARMCM4_STM32F4_Olimex_STM32E407_GCC\**Prog**\cmd\**clean.bat**". Next, build the demo program by double-clicking the file "\Target\Demo\ARMCM4_STM32F4_Olimex_STM32E407_GCC\**Prog**\cmd\**build.bat**". The output should look like: | + | To build the user program, open a command prompt in directory **\Target\Demo\ARMCM4_STM32F4_Olimex_STM32E407_GCC\Prog\** and run the command: |
+ | |||
+ | <code> | ||
+ | make clean all | ||
+ | </code> | ||
+ | |||
+ | The expected output is: | ||
<code> | <code> |