User Tools

Site Tools


manual:demos:olimex_stm32e407_iar

This is an old revision of the document!


ARM-CM4 STM32 Olimex STM32E407 IAR EWARM

Supported firmware update interfaces

UART CAN USB TCP/IP SD-card
Yes Yes Yes Yes Yes

Development Environment

This demo is targeted towards the Olimex STM32E407 board, with 1 MB internal Flash EEPROM and 196 kB internal RAM.

To program the bootloader into the internal flash on the STM32F407 microcontroller, the Segger J-Link JTAG interface was used. However, this is not required if you have another means of programming the internal flash.

A MOD-USB-RS232 was connected to the EXT connector of the board to establish a serial communication connection between the board and the PC.

To compile the demo programs you can use the IAR Embedded Workbench for ARM development environment.

Building and programming the Bootloader

Before the bootloader can be used, it needs to be built and programmed into the STM32F407's internal flash memory. The steps in this section only need to be done once.

When using IAR EWARM, simply open the workspace from within the Embedded Workbench. The workspace file (stm32f407.eww) is located at: \Target\Demo\ARMCM4_STM32F4_Olimex_STM32E407_IAR\Boot\ide\. Once opened, select Project→Rebuild All from the menu to compile all the bootloader sources and link the together into the final executable.

The bootloader program is now ready to be programmed into the internal flash memory of the STM32F407. Using your favorite programmer, flash the bootloader using one of the following files, depending on what file type your programmer supports:

  • \Target\Demo\ARMCM4_STM32F4_Olimex_STM32E407_IAR\Boot\bin\openblt_olimex_stm32e407.elf
  • \Target\Demo\ARMCM4_STM32F4_Olimex_STM32E407_IAR\Boot\bin\openblt_olimex_stm32e407.srec

Building the Demo Program

When using IAR EWARM, simply open the workspace from within the Embedded Workbench. The workspace file (stm32f407.eww) is located at: \Target\Demo\ARMCM4_STM32F4_Olimex_STM32E407_IAR\Prog\ide\. Once opened, select Project→Rebuild All from the menu to compile all the demo program sources and link the together into the final executable.

The output file is

  • \Target\Demo\ARMCM4_STM32F4_Olimex_STM32E407_IAR\Prog\bin\demoprog_olimex_stm32e407.srec

Firmware update procedure

To download the demo program \Target\Demo\ARMCM4_STM32F4_Olimex_STM32E407_IAR\Prog\bin\demoprog_olimex_stm32e407.srec using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use:

manual/demos/olimex_stm32e407_iar.1477315009.txt.gz · Last modified: 2019/09/24 22:13 (external edit)