User Tools

Site Tools


manual:demos:olimex_stm32h103_gcc

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
manual:demos:olimex_stm32h103_gcc [2017/08/17 11:55]
voorburg
manual:demos:olimex_stm32h103_gcc [2023/12/04 22:19] (current)
voorburg [Supported firmware update interfaces]
Line 3: Line 3:
 ===== Supported firmware update interfaces ===== ===== Supported firmware update interfaces =====
  
-UART           ^ CAN             ​^ USB          ^ TCP/​IP ​      ​^ SD-card ​     ^ +RS232         ^ CAN            ^ USB         ​^ TCP/​IP ​     ^ SD-card ​     ​^ Modbus RTU   
-| No             ​| No              | Yes          | No           | No           |+| No            | No             ​| Yes         | No          | No           | No           |
  
 ===== Development Environment ===== ===== Development Environment =====
Line 55: Line 55:
 ===== Building the Demo Program ===== ===== Building the Demo Program =====
  
-Before the bootloader can be used, it needs to be built and programmed into the STM32F103'​s internal flash memory. The steps in this section only need to be done once. +To build the user program, open a command prompt in directory **\Target\Demo\ARMCM3_STM32F1_Olimex_STM32H103_GCC\Prog\** and run the command:
- +
-To build the bootloader, open a command prompt in directory **\Target\Demo\ARMCM3_STM32F1_Olimex_STM32H103_GCC\Boot\** and run the command:+
  
 <​code>​ <​code>​
manual/demos/olimex_stm32h103_gcc.1502963705.txt.gz · Last modified: 2019/09/24 22:13 (external edit)