This demo is targeted towards the Olimex STM32-P207 board, with 512 kB internal Flash EEPROM and 128 kB internal RAM.

To program the bootloader into the internal flash on the STM32F207 microcontroller, the Segger J-Link JTAG interface was used. However, this is not required if you have another means of programming the internal flash.

To build the demo programs you can use the GNU ARM Embedded toolchain.

Firmware updates via the serial communication port are preconfigured to use USART3 on connector RS232_2 on the board.

The demo programs are configured for building with a Makefile. Before attempting to perform a build, update the location of the toolchain binaries (i.e. arm-none-eabi-gcc) in the Makefile. It is set in variable TOOL_PATH. If the toolchain binaries are available on the path, then the TOOL_PATH variable can be left empty.

It is assumed that tools such as GNU make and rm are installed and available on the path. For (Ubuntu) Linux users this can be achieved by running command: sudo apt-get install build-essential. Windows users can install the GNU MCU Eclipse Windows Build Tools.

Before the bootloader can be used, it needs to be built and programmed into the STM32F207's internal flash memory. The steps in this section only need to be done once.

To build the bootloader, open a command prompt in directory \Target\Demo\ARMCM3_STM32F2_Olimex_STM32P207_GCC\Boot\ and run the command:

make clean all

The expected output is:

+++ Cleaning build environment
+++ Clean complete
+++ Assembling [startup_stm32f2xx.S]
+++ Compiling [main.c]
+++ Compiling [hooks.c]
...
+++ Linking [openblt_stm32f207.elf]
..
+++ Build complete [openblt_stm32f207.srec]

The bootloader program is now ready to be programmed into the internal flash memory of the STM32F207. Using your favorite programmer (i.e. OpenOCD, Segger J-Flash Lite or STM32 ST-Link utility), flash the bootloader using one of the following files, depending on what file type your programmer supports:

• \Target\Demo\ARMCM3_STM32F2_Olimex_STM32P207_GCC\Boot\bin\openblt_stm32f207.elf
• \Target\Demo\ARMCM3_STM32F2_Olimex_STM32P207_GCC\Boot\bin\openblt_stm32f207.srec

To build the user program, open a command prompt in directory \Target\Demo\ARMCM3_STM32F2_Olimex_STM32P207_GCC\Prog\ and run the command:

make clean all

The expected output is:

+++ Cleaning build environment
+++ Clean complete
+++ Assembling [startup_stm32f2xx.S]
+++ Compiling [boot.c]
+++ Compiling [main.c]
...
+++ Linking [demoprog_stm32f207.elf]
...
+++ Build complete [demoprog_stm32f207.srec]

The output file is

• \Target\Demo\ARMCM3_STM32F2_Olimex_STM32P207_GCC\Prog\bin\demoprog_stm32f207.srec

To download the demo program \Target\Demo\ARMCM3_STM32F2_Olimex_STM32P207_GCC\Prog\bin\demoprog_stm32f207.srec using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use:

• Firmware updates using the RS232 communication interface
• Firmware updates using the CAN communication interface
• Firmware updates from SD-card