This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
manual:demos:olimex_stm32p207_gcc [2016/07/23 18:31] voorburg [Supported firmware update interfaces] |
manual:demos:olimex_stm32p207_gcc [2016/07/23 18:33] voorburg [Development Environment] |
||
---|---|---|---|
Line 16: | Line 16: | ||
To compile the demo programs you can use the [[http://www.emblocks.org/|EmBitz]] development environment from Em::Blocks. The version that was used to create these demo programs was {{:manual:embitz_0_42.zip?linkonly|EmBitz version 0.42}}. | To compile the demo programs you can use the [[http://www.emblocks.org/|EmBitz]] development environment from Em::Blocks. The version that was used to create these demo programs was {{:manual:embitz_0_42.zip?linkonly|EmBitz version 0.42}}. | ||
- | Firmware update via the serial communication port are preconfigured to use USART3 on connector RS232_2 on the board. | + | Firmware updates via the serial communication port are preconfigured to use USART3 on connector RS232_2 on the board. |
Line 47: | Line 47: | ||
* [[manual:uart_demo|Firmware updates using the UART communication interface]] | * [[manual:uart_demo|Firmware updates using the UART communication interface]] | ||
+ | * [[manual:can_demo|Firmware updates using the CAN communication interface]] | ||
* [[manual:sdcard_demo|Firmware updates from SD-card]] | * [[manual:sdcard_demo|Firmware updates from SD-card]] | ||