This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
manual:demos:olimex_stm32p207_gcc [2016/07/23 18:33] voorburg [Development Environment] |
manual:demos:olimex_stm32p207_gcc [2016/10/12 17:13] voorburg |
||
---|---|---|---|
Line 14: | Line 14: | ||
To program the bootloader into the internal flash on the STM32F207 microcontroller, the [[http://www.segger.com/development-tools.html|Segger J-Link]] JTAG interface was used. However, this is not required if you have another means of programming the internal flash. | To program the bootloader into the internal flash on the STM32F207 microcontroller, the [[http://www.segger.com/development-tools.html|Segger J-Link]] JTAG interface was used. However, this is not required if you have another means of programming the internal flash. | ||
- | To compile the demo programs you can use the [[http://www.emblocks.org/|EmBitz]] development environment from Em::Blocks. The version that was used to create these demo programs was {{:manual:embitz_0_42.zip?linkonly|EmBitz version 0.42}}. | + | To compile the demo programs you can use the [[http://www.emblocks.org/|EmBitz]] development environment from Em::Blocks. The version that was used to create these demo programs was {{:manual:embitz_1_00.zip?linkonly|EmBitz version 1.00}}. |
Firmware updates via the serial communication port are preconfigured to use USART3 on connector RS232_2 on the board. | Firmware updates via the serial communication port are preconfigured to use USART3 on connector RS232_2 on the board. |