This shows you the differences between two versions of the page.
Next revision Both sides next revision | |||
manual:demos:olimex_stm32p207_iar [2018/01/03 15:00] voorburg created |
manual:demos:olimex_stm32p207_iar [2018/01/03 15:01] voorburg [Building and programming the Bootloader] |
||
---|---|---|---|
Line 20: | Line 20: | ||
===== Building and programming the Bootloader ===== | ===== Building and programming the Bootloader ===== | ||
- | Before the bootloader can be used, it needs to be built and programmed into the STM32F107's internal flash memory. The steps in this section only need to be done once. | + | Before the bootloader can be used, it needs to be built and programmed into the STM32F207's internal flash memory. The steps in this section only need to be done once. |
When using IAR EWARM, simply open the workspace from within the Embedded Workbench. The workspace file (stm32f207.eww) is located at: \Target\Demo\ARMCM3_STM32F2_Olimex_STM32P207_IAR\**Boot**\ide\. Once opened, select Project->Rebuild All from the menu to compile all the bootloader sources and link the together into the final executable. | When using IAR EWARM, simply open the workspace from within the Embedded Workbench. The workspace file (stm32f207.eww) is located at: \Target\Demo\ARMCM3_STM32F2_Olimex_STM32P207_IAR\**Boot**\ide\. Once opened, select Project->Rebuild All from the menu to compile all the bootloader sources and link the together into the final executable. |