This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
manual:demos:olimex_stm32p207_iar [2018/01/03 15:00] voorburg created |
manual:demos:olimex_stm32p207_iar [2023/12/04 22:24] (current) voorburg [Supported firmware update interfaces] |
||
---|---|---|---|
Line 3: | Line 3: | ||
===== Supported firmware update interfaces ===== | ===== Supported firmware update interfaces ===== | ||
- | ^ UART ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ | + | ^ RS232 ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ Modbus RTU ^ |
- | | Yes | Yes | No | No | Yes | | + | | Yes | Yes | No | No | Yes | No | |
===== Development Environment ===== | ===== Development Environment ===== | ||
Line 20: | Line 20: | ||
===== Building and programming the Bootloader ===== | ===== Building and programming the Bootloader ===== | ||
- | Before the bootloader can be used, it needs to be built and programmed into the STM32F107's internal flash memory. The steps in this section only need to be done once. | + | Before the bootloader can be used, it needs to be built and programmed into the STM32F207's internal flash memory. The steps in this section only need to be done once. |
When using IAR EWARM, simply open the workspace from within the Embedded Workbench. The workspace file (stm32f207.eww) is located at: \Target\Demo\ARMCM3_STM32F2_Olimex_STM32P207_IAR\**Boot**\ide\. Once opened, select Project->Rebuild All from the menu to compile all the bootloader sources and link the together into the final executable. | When using IAR EWARM, simply open the workspace from within the Embedded Workbench. The workspace file (stm32f207.eww) is located at: \Target\Demo\ARMCM3_STM32F2_Olimex_STM32P207_IAR\**Boot**\ide\. Once opened, select Project->Rebuild All from the menu to compile all the bootloader sources and link the together into the final executable. | ||
Line 43: | Line 43: | ||
To download the demo program \Target\Demo\ARMCM3_STM32F2_Olimex_STM32P207_IAR\**Prog**\bin\**demoprog_stm32f207.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: | To download the demo program \Target\Demo\ARMCM3_STM32F2_Olimex_STM32P207_IAR\**Prog**\bin\**demoprog_stm32f207.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: | ||
- | * [[manual:uart_demo|Firmware updates using the UART communication interface]] | + | * [[manual:rs232_demo|Firmware updates using the RS232 communication interface]] |
* [[manual:can_demo|Firmware updates using the CAN communication interface]] | * [[manual:can_demo|Firmware updates using the CAN communication interface]] | ||
* [[manual:sdcard_demo|Firmware updates from SD-card]] | * [[manual:sdcard_demo|Firmware updates from SD-card]] | ||