This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
manual:demos:olimex_stm32p405_gcc [2017/07/18 11:18] voorburg |
manual:demos:olimex_stm32p405_gcc [2023/12/04 22:28] (current) voorburg [Supported firmware update interfaces] |
||
---|---|---|---|
Line 3: | Line 3: | ||
===== Supported firmware update interfaces ===== | ===== Supported firmware update interfaces ===== | ||
- | ^ UART ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ | + | ^ RS232 ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ Modbus RTU ^ |
- | | Yes | Yes | Yes | No | Yes | | + | | Yes | Yes | Yes | No | Yes | No | |
===== Development Environment ===== | ===== Development Environment ===== | ||
Line 49: | Line 49: | ||
</code> | </code> | ||
- | The bootloader program is now ready to be programmed into the internal flash memory of the STM32F405. Using your favorite programmer (i.e. OpenOCD, Segger J-Flash Lite, or STM32 ST-Link utility), flash the bootloader using one of the following files, depending on what file type your programmer supports: | + | The bootloader program is now ready to be programmed into the internal flash memory of the STM32F405. Using your favorite programmer (i.e. OpenOCD, Segger J-Flash Lite or STM32 ST-Link utility), flash the bootloader using one of the following files, depending on what file type your programmer supports: |
* \Target\Demo\ARMCM4_STM32F4_Olimex_STM32P405_GCC\**Boot**\bin\**openblt_olimex_stm32p405.elf** | * \Target\Demo\ARMCM4_STM32F4_Olimex_STM32P405_GCC\**Boot**\bin\**openblt_olimex_stm32p405.elf** | ||
Line 84: | Line 84: | ||
To download the demo program \Target\Demo\ARMCM4_STM32F4_Olimex_STM32P405_GCC\**Prog**\bin\**demoprog_olimex_stm32p405.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: | To download the demo program \Target\Demo\ARMCM4_STM32F4_Olimex_STM32P405_GCC\**Prog**\bin\**demoprog_olimex_stm32p405.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: | ||
- | * [[manual:uart_demo|Firmware updates using the UART communication interface]] | + | * [[manual:rs232_demo|Firmware updates using the RS232 communication interface]] |
* [[manual:can_demo|Firmware updates using the CAN communication interface]] | * [[manual:can_demo|Firmware updates using the CAN communication interface]] | ||
* [[manual:usb_demo|Firmware updates using the USB communication interface]] | * [[manual:usb_demo|Firmware updates using the USB communication interface]] |