This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
manual:demos:olimex_stm32p405_truestudio [2017/07/17 17:10] voorburg [Supported firmware update interfaces] |
manual:demos:olimex_stm32p405_truestudio [2020/07/01 07:44] (current) voorburg [Firmware update procedure] |
||
---|---|---|---|
Line 3: | Line 3: | ||
===== Supported firmware update interfaces ===== | ===== Supported firmware update interfaces ===== | ||
- | ^ UART ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ | + | ^ RS232 ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ |
| Yes | Yes | Yes | No | Yes | | | Yes | Yes | Yes | No | Yes | | ||
Line 12: | Line 12: | ||
This demo is targeted towards the [[https://www.olimex.com/Products/ARM/ST/STM32-P405/|Olimex STM32-P405]] board, with 1024 kB internal Flash EEPROM and 192 kB internal RAM. | This demo is targeted towards the [[https://www.olimex.com/Products/ARM/ST/STM32-P405/|Olimex STM32-P405]] board, with 1024 kB internal Flash EEPROM and 192 kB internal RAM. | ||
- | To compile the demo programs you can use the [[https://atollic.com/truestudio/|Atollic TrueStudio]] development environment. The freely available Lite-edition suffices. Note the Atollic TrueStudio is cross-platform. The information outlined on this page applies to both Microsoft Windows and Linux users. | + | To compile the demo programs you can use the [[https://atollic.com/truestudio/|Atollic TrueStudio]] development environment. Note the Atollic TrueStudio is cross-platform. The information outlined on this page applies to both Microsoft Windows and Linux users. |
To program the bootloader into the internal flash on the STM32F405 microcontroller, the [[http://www.segger.com/development-tools.html|Segger J-Link]] JTAG interface was used. However, this is not required if you have another means of programming the internal flash. | To program the bootloader into the internal flash on the STM32F405 microcontroller, the [[http://www.segger.com/development-tools.html|Segger J-Link]] JTAG interface was used. However, this is not required if you have another means of programming the internal flash. | ||
Line 56: | Line 56: | ||
To download the demo program \Target\Demo\ARMCM4_STM32F4_Olimex_STM32P405_TrueStudio\**Prog**\Debug\**demoprog_olimex_stm32p405.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: | To download the demo program \Target\Demo\ARMCM4_STM32F4_Olimex_STM32P405_TrueStudio\**Prog**\Debug\**demoprog_olimex_stm32p405.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: | ||
- | * [[manual:uart_demo|Firmware updates using the UART communication interface]] | + | * [[manual:rs232_demo|Firmware updates using the RS232 communication interface]] |
* [[manual:can_demo|Firmware updates using the CAN communication interface]] | * [[manual:can_demo|Firmware updates using the CAN communication interface]] | ||
+ | * [[manual:usb_demo|Firmware updates using the USB communication interface]] | ||
+ | * [[manual:sdcard_demo|Firmware updates from SD-card]] | ||