manual:demos:s32k144_evb_iar
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
manual:demos:s32k144_evb_iar [2020/03/20 18:00] voorburg [Development Environment] |
manual:demos:s32k144_evb_iar [2020/03/20 18:00] voorburg [Development Environment] |
||
|---|---|---|---|
| Line 14: | Line 14: | ||
| To program the bootloader into the internal flash on the S32K144 microcontroller, a [[https://www.segger.com/products/debug-probes/j-link/|Segger J-Link]] debugger interface was used, in combination with a [[https://www.olimex.com/Products/ARM/JTAG/ARM-JTAG-20-10/|ARM-JTAG-20-10]] adapter. However, this is not required if you have another means of programming the internal flash. | To program the bootloader into the internal flash on the S32K144 microcontroller, a [[https://www.segger.com/products/debug-probes/j-link/|Segger J-Link]] debugger interface was used, in combination with a [[https://www.olimex.com/Products/ARM/JTAG/ARM-JTAG-20-10/|ARM-JTAG-20-10]] adapter. However, this is not required if you have another means of programming the internal flash. | ||
| - | To compile the demo programs you can use the [[https://www.olimex.com/Products/ARM/JTAG/ARM-JTAG-20-10/|IAR Embedded Workbench for ARM]]. | + | To compile the demo programs you can use the [[https://www.iar.com/|IAR Embedded Workbench for ARM]]. |
| When performing updates via CAN, make sure to configure the board such that it is powered with a 12V power source (jumper J107), instead of via USB, otherwise the CAN transceiver on the board is not powered. | When performing updates via CAN, make sure to configure the board such that it is powered with a 12V power source (jumper J107), instead of via USB, otherwise the CAN transceiver on the board is not powered. | ||
manual/demos/s32k144_evb_iar.txt ยท Last modified: 2023/12/04 22:38 by voorburg
Page Tools
