User Tools

Site Tools


manual:demos:s32k144_evb_iar

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
manual:demos:s32k144_evb_iar [2020/03/20 18:00]
voorburg [Development Environment]
manual:demos:s32k144_evb_iar [2020/03/20 18:00] (current)
voorburg [Development Environment]
Line 14: Line 14:
 To program the bootloader into the internal flash on the S32K144 microcontroller,​ a [[https://​www.segger.com/​products/​debug-probes/​j-link/​|Segger J-Link]] debugger interface was used, in combination with a [[https://​www.olimex.com/​Products/​ARM/​JTAG/​ARM-JTAG-20-10/​|ARM-JTAG-20-10]] adapter. However, this is not required if you have another means of programming the internal flash. ​ To program the bootloader into the internal flash on the S32K144 microcontroller,​ a [[https://​www.segger.com/​products/​debug-probes/​j-link/​|Segger J-Link]] debugger interface was used, in combination with a [[https://​www.olimex.com/​Products/​ARM/​JTAG/​ARM-JTAG-20-10/​|ARM-JTAG-20-10]] adapter. However, this is not required if you have another means of programming the internal flash. ​
  
-To compile the demo programs you can use the [[https://​www.olimex.com/​Products/​ARM/​JTAG/​ARM-JTAG-20-10/|IAR Embedded Workbench for ARM]]. ​+To compile the demo programs you can use the [[https://​www.iar.com/|IAR Embedded Workbench for ARM]]. ​
  
 When performing updates via CAN, make sure to configure the board such that it is powered with a 12V power source (jumper J107), instead of via USB, otherwise the CAN transceiver on the board is not powered. When performing updates via CAN, make sure to configure the board such that it is powered with a 12V power source (jumper J107), instead of via USB, otherwise the CAN transceiver on the board is not powered.
manual/demos/s32k144_evb_iar.txt ยท Last modified: 2020/03/20 18:00 by voorburg