This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
manual:demos:stm32f3_discovery_cubeide [2020/12/01 12:15] voorburg created |
manual:demos:stm32f3_discovery_cubeide [2023/12/04 22:25] (current) voorburg [Supported firmware update interfaces] |
||
---|---|---|---|
Line 3: | Line 3: | ||
===== Supported firmware update interfaces ===== | ===== Supported firmware update interfaces ===== | ||
- | ^ RS232 ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ | + | ^ RS232 ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ Modbus RTU ^ |
- | | No | No | Yes | No | No | | + | | No | No | Yes | No | No | No | |
===== Development Environment ===== | ===== Development Environment ===== | ||
Line 35: | Line 35: | ||
- Set the project as the active project in Eclipse. This is achieved by clicking the **Boot** project in the //Project Explorer// to select it. | - Set the project as the active project in Eclipse. This is achieved by clicking the **Boot** project in the //Project Explorer// to select it. | ||
- | - Delete the file \Target\Demo\ARMCM4_STM32F3_Discovery_F303VC_CubeIDE\**Boot**\Debug\**openblt_stm32f303.elf**. | ||
- Next, right-click the **Boot** project in the //Project Explorer// and select //Refresh// from the popup menu. | - Next, right-click the **Boot** project in the //Project Explorer// and select //Refresh// from the popup menu. | ||
- Finally, right-click the **Boot** project in the //Project Explorer// and select //Build Project// from the popup menu to compile all the bootloader sources and link them together into the final executable. | - Finally, right-click the **Boot** project in the //Project Explorer// and select //Build Project// from the popup menu to compile all the bootloader sources and link them together into the final executable. | ||
Line 49: | Line 48: | ||
- Set the project as the active project in Eclipse. This is achieved by clicking the **Prog** project in the //Project Explorer// to select it. | - Set the project as the active project in Eclipse. This is achieved by clicking the **Prog** project in the //Project Explorer// to select it. | ||
- | - Delete the file \Target\Demo\ARMCM4_STM32F3_Discovery_F303VC_CubeIDE\**Prog**\Debug\**demoprog_stm32f303.elf**. | ||
- Next, right-click the **Prog** project in the //Project Explorer// and select //Refresh// from the popup menu. | - Next, right-click the **Prog** project in the //Project Explorer// and select //Refresh// from the popup menu. | ||
- Finally, right-click the **Prog** project in the //Project Explorer// and select //Build Project// from the popup menu to compile all the user program sources and link them together into the final executable. | - Finally, right-click the **Prog** project in the //Project Explorer// and select //Build Project// from the popup menu to compile all the user program sources and link them together into the final executable. |