User Tools

Site Tools


manual:demos:stm32f3_discovery_gcc

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
manual:demos:stm32f3_discovery_gcc [2018/06/11 15:43]
voorburg [Building the Demo Program]
manual:demos:stm32f3_discovery_gcc [2023/12/04 22:25] (current)
voorburg [Supported firmware update interfaces]
Line 3: Line 3:
 ===== Supported firmware update interfaces ===== ===== Supported firmware update interfaces =====
  
-UART           ^ CAN             ​^ USB          ^ TCP/​IP ​      ​^ SD-card ​     ^ +RS232         ^ CAN            ^ USB         ​^ TCP/​IP ​     ^ SD-card ​     ​^ Modbus RTU   
-| No             ​| No              | Yes           ​| No           | No           |+| No            | No             ​| Yes         | No          ​| No           | No           |
  
 ===== Development Environment ===== ===== Development Environment =====
Line 83: Line 83:
 ===== Firmware update procedure ===== ===== Firmware update procedure =====
  
-To download the demo program \Target\Demo\ARMCM4_STM32F3_Discovery_F303VC_TrueStudio\**Prog**\Debug\**demoprog_stm32f303.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use:+To download the demo program \Target\Demo\ARMCM4_STM32F3_Discovery_F303VC_GCC\**Prog**\bin\**demoprog_stm32f303.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use:
  
   * [[manual:​usb_demo|Firmware updates using the USB communication interface]]   * [[manual:​usb_demo|Firmware updates using the USB communication interface]]
  
 For firmware updates via USB, keep in mind that the USB cable should be connected to the USB USER connector on the board and not the USB ST-LINK connector. For firmware updates via USB, keep in mind that the USB cable should be connected to the USB USER connector on the board and not the USB ST-LINK connector.
manual/demos/stm32f3_discovery_gcc.1528724632.txt.gz · Last modified: 2019/09/24 22:13 (external edit)