This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
manual:demos:stm32f3_discovery_iar [2018/06/11 22:21] voorburg [Building the Demo Program] |
manual:demos:stm32f3_discovery_iar [2023/12/04 22:25] (current) voorburg [Supported firmware update interfaces] |
||
---|---|---|---|
Line 3: | Line 3: | ||
===== Supported firmware update interfaces ===== | ===== Supported firmware update interfaces ===== | ||
- | ^ UART ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ | + | ^ RS232 ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ Modbus RTU ^ |
- | | No | No | Yes | No | No | | + | | No | No | Yes | No | No | No | |
===== Development Environment ===== | ===== Development Environment ===== | ||
Line 40: | Line 40: | ||
===== Firmware update procedure ===== | ===== Firmware update procedure ===== | ||
- | To download the demo program \Target\Demo\ARMCM4_STM32F3_Discovery_F303VC_GCC\**Prog**\bin\**demoprog_stm32f303.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: | + | To download the demo program \Target\Demo\ARMCM4_STM32F3_Discovery_F303VC_IAR\**Prog**\bin\**demoprog_stm32f303.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: |
* [[manual:usb_demo|Firmware updates using the USB communication interface]] | * [[manual:usb_demo|Firmware updates using the USB communication interface]] | ||
For firmware updates via USB, keep in mind that the USB cable should be connected to the USB USER connector on the board and not the USB ST-LINK connector. | For firmware updates via USB, keep in mind that the USB cable should be connected to the USB USER connector on the board and not the USB ST-LINK connector. |