This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
manual:demos:stm32f3_discovery_truestudio [2018/06/11 15:02] voorburg [Building the Demo Program] |
manual:demos:stm32f3_discovery_truestudio [2018/06/11 15:05] voorburg [Firmware update procedure] |
||
---|---|---|---|
Line 53: | Line 53: | ||
===== Firmware update procedure ===== | ===== Firmware update procedure ===== | ||
- | To download the demo program \Target\Demo\ARMCM4_STM32F3_Nucleo_F303K8_TrueStudio\**Prog**\Debug\**demoprog_stm32f303.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: | + | To download the demo program \Target\Demo\ARMCM4_STM32F3_Discovery_F303VC_TrueStudio\**Prog**\Debug\**demoprog_stm32f303.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: |
- | + | ||
- | * [[manual:uart_demo|Firmware updates using the UART communication interface]] | + | |
- | * [[manual:can_demo|Firmware updates using the CAN communication interface]] | + | |
+ | * [[manual:usb_demo|Firmware updates using the USB communication interface]] | ||
+ | For firmware updates via USB, keep in mind that the USB cable should be connected to the USB USER connector on the board and not the USB ST-LINK connector. |