manual:demos:tc375_lite_kit_ads
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
manual:demos:tc375_lite_kit_ads [2022/11/07 18:30] voorburg [Building the Demo Program] |
manual:demos:tc375_lite_kit_ads [2023/12/04 22:41] (current) voorburg [Supported firmware update interfaces] |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ===== Supported firmware update interfaces ===== | ===== Supported firmware update interfaces ===== | ||
| - | ^ RS232 ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ | + | ^ RS232 ^ CAN ^ USB ^ TCP/IP ^ SD-card ^ Modbus RTU ^ |
| - | | Yes | Yes | No | No | No | | + | | Yes | Yes | No | No | No | No | |
| ===== Development Environment ===== | ===== Development Environment ===== | ||
| Line 13: | Line 13: | ||
| - | To compile the demo programs you can use the [[https://www.infineon.com/cms/en/product/promopages/aurix-development-studio/|AURIX Development Studio]] | + | To compile the demo programs you can use the [[https://www.infineon.com/cms/en/product/promopages/aurix-development-studio/|AURIX Development Studio]]. |
| To program the bootloader into the internal flash, the on-board miniWiggler interface was used. Firmware updates via the serial communication port are preconfigured to use the virtual COM-port offered by the miniWiggler. This means that no additional hardware is needed, besides a standard micro-USB cable. | To program the bootloader into the internal flash, the on-board miniWiggler interface was used. Firmware updates via the serial communication port are preconfigured to use the virtual COM-port offered by the miniWiggler. This means that no additional hardware is needed, besides a standard micro-USB cable. | ||
| Line 55: | Line 55: | ||
| ===== Firmware update procedure ===== | ===== Firmware update procedure ===== | ||
| - | To download the demo program \Target\Demo\ARMCM7_STM32F7_Nucleo_F767ZI_CubeIDE\**Prog**\Debug\**demoprog_stm32f767.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: | + | To download the demo program \Target\Demo\TRICORE_TC3_TC375_Lite_Kit_ADS\**Prog**\Debug\**demoprog_tc375.srec** using the bootloader, follow the instructions in the following links, depending on the communication interface you intend to use: |
| * [[manual:rs232_demo|Firmware updates using the RS232 communication interface]] | * [[manual:rs232_demo|Firmware updates using the RS232 communication interface]] | ||
| - | * [[manual:net_demo|Firmware updates using the TCP/IP communication interface]] | + | * [[manual:can_demo|Firmware updates using the CAN communication interface]] |
manual/demos/tc375_lite_kit_ads.1667842211.txt.gz · Last modified: 2022/11/07 18:30 by voorburg
Page Tools
