manual:demos:usb_driver_install
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
manual:demos:usb_driver_install [2020/01/16 11:04] voorburg |
manual:demos:usb_driver_install [2023/06/27 09:44] voorburg |
||
|---|---|---|---|
| Line 4: | Line 4: | ||
| ===== USB Driver Installation on Windows ===== | ===== USB Driver Installation on Windows ===== | ||
| + | |||
| + | |||
| + | ---- | ||
| + | **New**: Starting with OpenBLT version 1.16, you no longer need to install the USB driver. This applies to all demo programs that are configured to support firmware updates via USB. Therefore, you can skip the information in this section. | ||
| + | |||
| + | Here's how it works: During USB enumeration, a Microsoft 2.0 descriptor set is now sent to the PC, which automatically enters the WinUSB Device Interface GUID into the registry and links it to OpenBLT's VID/PID. | ||
| + | ---- | ||
| Before installing the USB driver, make sure the USB device that runs the OpenBLT USB bootloader is not connected to your PC. If a prior version of the USB driver was installed, it is recommended to first uninstall this driver. | Before installing the USB driver, make sure the USB device that runs the OpenBLT USB bootloader is not connected to your PC. If a prior version of the USB driver was installed, it is recommended to first uninstall this driver. | ||
manual/demos/usb_driver_install.txt ยท Last modified: 2023/06/27 10:02 by voorburg
Page Tools
