OpenBLT Bootloader

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== ARM Cortex-M0 for Infineon XMC1xxx ======

===== Bootloader size =====

Due to the presence of the bootloader in the on-chip flash memory, the start address of the user program needs to be adjusted so make sure both programs do not overlap. Additionally, the bootloader's flash driver needs to be properly configured to prevent accidental erasure of the bootloader during firmware updates.

To reserve flash memory for the bootloader and protect it from being erased and/or reprogrammed during firmware updates, comment out lines in table flashLayout[] in source-file **flash.c**. Refer to the demo bootloader program for an example.

{{:manual:ports:infineon_xmc1_flash_layout.png?|}}

Adjusting the start address of the user program in flash to make sure it doesn't overlap with the bootloader, is achieved by changing the program's ROM start address in the linker descriptor file. Set it to the start address as present in the first line in table flashLayout[] that is not commented out. In the previous example, this is 0x10003000:

{{:manual:ports:infineon_xmc1_rom_reservation.png?|}}


===== Checksum location =====

A 32-bit checksum value is programmed by the bootloader at the end of a programming session. Upon startup, the bootloader verifies the correctness of this checksum to determine if a valid user program is present and can be started.

The bootloader programs this value at the end of the user program's vector table. Its exact location is configured by macro BOOT_FLASH_VECTOR_TABLE_CS_OFFSET in flash.c. The vector table size can vary based on the microcontroller derivative you are using. Please verify that the default value of BOOT_FLASH_VECTOR_TABLE_CS_OFFSET is correct. If not, you can simply override the value by adding the macro with the correct value to the blt_conf.h configuration header file.

The user program must reserve space for this 32-bit checksum value. To reserve this space, simply enter one extra dummy entry into the interrupt vector table. This reserves space for the checksum at memory address: flash base address + flash reserved for bootloader  + FLASH_VECTOR_TABLE_CS_OFFSET. Refer to the demo program for an example.

{{:manual:ports:infineon_xmc1_checksum_reservation.png?|}}


===== Stackpointer initialization =====

On the ARM Cortex-M0 the first entry into the vector table holds the initialization value for the stackpointer, which is automatically loaded into the CPU's stackpointer register upon reset.

After reset, the bootloader gets started first and, if a valid user program is present, it is the bootloaders responsibility to start the user program. This unfortunately means that the automatic initialization of the CPU's stackpointer register does not work for the user program. The user program therefore needs to explicitly set the initial value of the CPU's stackpointer register in the reset interrupt service routine. Refer to the demo program for an example.

{{:manual:ports:infineon_xmc1_stackpointer_init.png?|}}
OpenBLT Bootloader

User Tools

Site Tools

Page Tools
