Differences

This shows you the differences between two versions of the page.

--- manual:ports:tricore_tc3 [2022/11/07 12:23]
voorburg [Post-process the Motorola S-record]
+++ manual:ports:tricore_tc3 [2023/09/18 11:29]
voorburg [Post-process the Motorola S-record]
@@ Line 58: / Line 58: @@
 Eclipse CDT based IDEs include a configuration option, where you can configure a command to run as a post-build step. This is the ideal location to call the batch-file:
+{{:manual:ports:tricore_tc3_postbuild_step.png|}}
+This approach work for version 1.9.8 and newer of the AURIX Development Studio. Older versions (e.g. 1.7.2) of the AURIX Development Studio have a problem with the post-build steps. Whatever command you enter will result in a build error.
+Luckily, there is a simple workaround for this. At the end of a build, the AURIX Development Studio calls the tool "elfsize" to print size information about the firmware's ROM and RAM usage. You can hijack its command to additionally call the "postbuild.bat" batch-file. Simply change the Print Size command line pattern from:
+<code>
+${COMMAND} ${INPUTS} ${FLAGS}
+</code>
+to:
+<code>
+${COMMAND} ${INPUTS} ${FLAGS} && ${ProjDirPath}/Cmd/postbuild.bat "${BuildArtifactFileBaseName}.srec"
+</code>
+{{:manual:ports:tricore_tc3_postbuild_hack.png|}}
+When the calling of the "postbuild.bat" batch-file is properly configured, you can see the following output in the Console-window at the end of the build:
+{{:manual:ports:tricore_tc3_postbuild_console.png|}}

OpenBLT Bootloader