User Tools

Site Tools


manual:uart_demo

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
manual:uart_demo [2018/07/02 13:31]
voorburg [Notes]
manual:uart_demo [2018/07/04 14:50]
voorburg [Using MicroBoot]
Line 10: Line 10:
  
  
-===== Using Microboot ​=====+===== Using MicroBoot ​=====
  
-The Microboot ​utility needs to be configured to connect to the correct COM-port and to communication at the correct baudrate:+The MicroBoot ​utility needs to be configured to connect to the correct COM-port and to communication at the correct baudrate:
  
-  * Start Microboot ​by double-clicking "​\Host\**MicroBoot.exe**"​ (on Linux it is "​\Host\**MicroBoot**"​).+  * Start MicroBoot ​by double-clicking "​\Host\**MicroBoot.exe**"​ (on Linux it is "​\Host\**MicroBoot**"​).
   * Click the "​**Settings**"​-button and select "**XCP on RS232**"​ from the "​Interface selection"​ dropdown box.   * Click the "​**Settings**"​-button and select "**XCP on RS232**"​ from the "​Interface selection"​ dropdown box.
   * Select the PC's communication device that the board is connected to.   * Select the PC's communication device that the board is connected to.
   * Select the baudrate to the value specified by macro BOOT_COM_UART_BAUDRATE in "​blt_conf.h"​. Typically, this is **57600** bits/sec for the demo programs.   * Select the baudrate to the value specified by macro BOOT_COM_UART_BAUDRATE in "​blt_conf.h"​. Typically, this is **57600** bits/sec for the demo programs.
  
-Once you saved the settings by clicking the "​**OK**"​-button, ​Microboot ​is now ready for action!+Once you saved the settings by clicking the "​**OK**"​-button, ​MicroBoot ​is now ready for action!
  
-After building your user program, its S-record formatted firmware file can be downloaded to the remaining flash memory using the bootloader. In **Microboot** click the "​**Browse**"​-button and select your user program'​s firmware file. For the demo programs, this one is located in the "​.\**Prog**\bin\"​ directory. Once the firmware file was selected, the download should automatically start. ​+After building your user program, its S-record formatted firmware file can be downloaded to the remaining flash memory using the bootloader. In **MicroBoot** click the "​**Browse**"​-button and select your user program'​s firmware file. For the demo programs, this one is located in the "​.\**Prog**\bin\"​ directory. Once the firmware file was selected, the download should automatically start. ​
  
 {{:​manual:​olimex_stm32p405_download.png?​|}} {{:​manual:​olimex_stm32p405_download.png?​|}}