manual:ports:armcm0_stm32
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
manual:ports:armcm0_stm32 [2016/04/29 16:38] voorburg [Bootloader size] |
manual:ports:armcm0_stm32 [2022/11/07 11:27] (current) voorburg [Checksum location] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== ARM Cortex-M0 for STM32F0xx ====== | ||
| + | |||
| ===== Bootloader size ===== | ===== Bootloader size ===== | ||
| Line 30: | Line 32: | ||
| A 32-bit checksum value is programmed by the bootloader at the end of a programming session. Upon startup, the bootloader verifies the correctness of this checksum to determine if a valid user program is present and can be started. | A 32-bit checksum value is programmed by the bootloader at the end of a programming session. Upon startup, the bootloader verifies the correctness of this checksum to determine if a valid user program is present and can be started. | ||
| - | The user program must reserve space for this 32-bit checksum value. The bootloader programs this value at the end of the interrupt vector table. To reserve this space, simply enter one extra dummy entry into the interrupt vector table. This reserves space for the checksum at memory address 0x080020C0 (0xC0 + flash reserved for bootloader + flash base address). Refer to the demo program for an example. | + | The bootloader programs this value at the end of the user program's vector table. Its exact location is configured by macro BOOT_FLASH_VECTOR_TABLE_CS_OFFSET in flash.c. The vector table size can vary based on the microcontroller derivative you are using. Please verify that the default value of BOOT_FLASH_VECTOR_TABLE_CS_OFFSET is correct. If not, you can simply override the value by adding the macro with the correct value to the blt_conf.h configuration header file. |
| + | |||
| + | The user program must reserve space for this 32-bit checksum value. To reserve this space, simply enter one extra dummy entry into the interrupt vector table. This reserves space for the checksum at memory address: flash base address + flash reserved for bootloader + FLASH_VECTOR_TABLE_CS_OFFSET. Refer to the demo program for an example. | ||
| {{:manual:ports:stm32_cm0_checksum_reservation.png?|}} | {{:manual:ports:stm32_cm0_checksum_reservation.png?|}} | ||
manual/ports/armcm0_stm32.1461940706.txt.gz · Last modified: 2019/09/24 22:14 (external edit)
Page Tools
