manual:ports:armcm0_stm32
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
manual:ports:armcm0_stm32 [2019/09/24 22:12] 127.0.0.1 external edit |
manual:ports:armcm0_stm32 [2022/11/07 11:27] (current) voorburg [Checksum location] |
||
|---|---|---|---|
| Line 32: | Line 32: | ||
| A 32-bit checksum value is programmed by the bootloader at the end of a programming session. Upon startup, the bootloader verifies the correctness of this checksum to determine if a valid user program is present and can be started. | A 32-bit checksum value is programmed by the bootloader at the end of a programming session. Upon startup, the bootloader verifies the correctness of this checksum to determine if a valid user program is present and can be started. | ||
| - | The bootloader programs this value at the end of the user program's vector table. Its exact location is configured by macro FLASH_VECTOR_TABLE_CS_OFFSET in flash.c. The vector table size can vary based on the microcontroller derivative you are using. Please verify that the default value of FLASH_VECTOR_TABLE_CS_OFFSET is correct. If not, you can simply override the value by adding the macro with the correct value to the blt_conf.h configuration header file. | + | The bootloader programs this value at the end of the user program's vector table. Its exact location is configured by macro BOOT_FLASH_VECTOR_TABLE_CS_OFFSET in flash.c. The vector table size can vary based on the microcontroller derivative you are using. Please verify that the default value of BOOT_FLASH_VECTOR_TABLE_CS_OFFSET is correct. If not, you can simply override the value by adding the macro with the correct value to the blt_conf.h configuration header file. |
| The user program must reserve space for this 32-bit checksum value. To reserve this space, simply enter one extra dummy entry into the interrupt vector table. This reserves space for the checksum at memory address: flash base address + flash reserved for bootloader + FLASH_VECTOR_TABLE_CS_OFFSET. Refer to the demo program for an example. | The user program must reserve space for this 32-bit checksum value. To reserve this space, simply enter one extra dummy entry into the interrupt vector table. This reserves space for the checksum at memory address: flash base address + flash reserved for bootloader + FLASH_VECTOR_TABLE_CS_OFFSET. Refer to the demo program for an example. | ||
manual/ports/armcm0_stm32.1569355959.txt.gz ยท Last modified: 2019/09/24 22:12 by 127.0.0.1
Page Tools
